برد Breakout مبدل RS485 به TTL
zoom_out_map
chevron_left chevron_right

برد Breakout مبدل RS485 به TTL

3011013017

برد برک آوت برای تبدیل ارتباط UART به RS485

تعداد تخفیف واحد قیمت کالا با تخفیف
20 3% 61,207‎تومان
631,000‎ریال (با مالیات) 631,000‎ریال (بدون مالیات)

Description

This is a breakout board for the MAX485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex transceiver, so it can only communicate one way at a time, but it can reach transmission speeds of up to 10Mbps. This board requires a very low amount of power and can operate from a single +3.3VDC supply.

This breakout board includes the MAX 485 RS-485 transceiver, filter capacitor, and other components shown on the schematic. We’ve broken out the RS-485 output to three different connections: (1) an RJ-45 connector, (2) a 3-pin 3.55mm screw terminal, and (3) a 3-pin 0.1" pitch header; none of these output connectors come populated.

Feature

Fully equipped with MAX485 RS-485 transceiver and supporting components
Operates from a single +3.3V supply
Interoperable with +5.0V logic
RS-485 input/output broken out to RJ-45 connector, 3.5mm screw terminal, and 0.1" pitch header
Driver/Receiver Enable connected to RTS line
-7V to +12V Common-Mode Input Voltage Range
Allows up to 32 transceivers on the serial bus
Driver Output Short-Circuit Protection
Dimensions: 0.9x1.0"

امتیاز شما

  • سید علیرضا عبدالاهیان | بیش از 3 سال قبل
    با سلام.
    تو دیتا شیت این تراشه ولتاژ رو حداکثر 3.6 ولت گفته و هم چنین گفته که بیشتر از این ولتاژ به تراشه آسیب میزنه. اما شما نوشتید ولتاژ پیشنهادی3 تا 5 ولت هست. در ماژول تقسیم ولتاژ زدید؟؟ الان بهترین ولتاژ پیشنهادی برای تغذیه ماژول چقدره؟
    پاسخ | گزارش
    0 thumb_down
    0 thumb_up
    • پشتیبانی فروشگاه | بیش از 3 سال قبل
      سلام، همان گونه که در توضیحات هم آمده است ولتاژ کاری +3.3 ولت است.
      پاسخ | گزارش
      0 thumb_down
      0 thumb_up
ویرایش نظر
  یا لغو