برد NUCLEO-64 STM32F411RE با پشتیبانی از آردوینو

The Nucleo F411RE board features an ARM Cortex-M4 based STM32F411RE MCU with a wide range of connectivity support and configurations. Here are some highlights of the Nucleo F411RE board:

• STM32 microcontroller in QFP64 package
• Two types of extension resources:
  • Arduino Uno V3 connectivity
  • ST morpho extension pin headers for full access to all STM32 I/Os
• On-board ST-LINK/V2-1 debugger/programmer with SWD connector
• Flexible board power supply:
  • USB VBUS or external source(3.3V, 5V, 7 - 12V)
  • Power management access point
• Three LEDs: USB communication (LD1), user LED (LD2), power LED (LD3)
• Two push-buttons: USER and RESET

Hardware

Nucleo F411RE provides the following hardware components:

• STM32F411RET6 in LQFP64 package
• ARM® 32-bit Cortex®-M4 CPU with FPU
• 100 MHz max CPU frequency
• VDD from 1.7 V to 3.6 V
• 512 KB Flash
• 128 KB SRAM
• GPIO with external interrupt capability
• 12-bit ADC with 16 channels, with FIFO and burst support
• RTC
• 8 General purpose timers
• 2 watchdog timers (independent and window)
• SysTick timer
• USART/UART (3)
• I2C (3)
• SPI (5)
• SDIO
• USB 2.0 OTG FS
• DMA Controller
• CRC calculation unit

More information about STM32F411RE can be found here:

• STM32F411RE on www.st.com
• STM32F411 reference manual

Connections and IOs

Nucleo F411RE Board has 8 GPIO controllers. These controllers are responsible for pin muxing, input/output, pull-up, etc.

For mode details please refer to STM32 Nucleo-64 board User Manual.

$ minicom -D /dev/ttyACM0

# On Linux/macOS
cd $ZEPHYR_BASE/samples/hello_world
mkdir build && cd build

# On Windows
cd %ZEPHYR_BASE%sampleshello_world
mkdir build & cd build


# Use cmake to configure a Ninja-based build system:
cmake -GNinja -DBOARD=nucleo_f411re ..

# Now run ninja on the generated build system:
ninja
ninja flash

$ Hello World! arm

# On Linux/macOS
cd $ZEPHYR_BASE/samples/hello_world
# If you already made a build directory (build) and ran cmake, just 'cd build' instead.
mkdir build && cd build

# On Windows
cd %ZEPHYR_BASE%sampleshello_world
# If you already made a build directory (build) and ran cmake, just 'cd build' instead.
mkdir build & cd build

# If you already made a build directory (build) and ran cmake, just 'cd build' instead.

# Use cmake to configure a Ninja-based build system:
cmake -GNinja -DBOARD=nucleo_f411re ..

# Now run ninja on the generated build system:
ninja debug